Protective Film - 102
Home Finishes Cut to Length Warehousing Architectural Finishes Protective Film Industry Links Contact Us
Preferably the film should be applied by mechanical means. Best results are obtained at an application temperature between15°C and 40°C.
Adhesive properties are susceptible to change due to following parameters: chemical and physical state of the surface to beprotected; presence of impurities within or on the substrate: elongation of the film during application; and temperature of surroundings and of substrate.
The film can be stored for six months, in its original packaging and in dry conditions. The rolls should be protected from extremes of temperature and direct sunlight. Out of its container, the film should be protected against dust and other impurities.
The thickness of the protective film has to be taken into account for the tolerances of any processing equipment cominginto contact with the film.

Tests should be conducted under actual applications conditions.
Film backing PVC
Colors White
Adhesive type Rubber
Adhesion level High
Total tape thickness 5.0 mils
Initial peel strength 225 gr/25mm on BA-Steel
7.9 oz./inch on BA-Steel
Unwinding force 150 gr/25mm
5.3 oz./inch
Tensile strength 8.8 kg/25mm
19.4 lbs/inch
Elongation at break 220%
Note: The above are typical values and should not be used in writing specifications.

The performance of all adhesive products is affected by many factors: heat, humidity, type of substrate, texture, inks used and application technique. Our suggestions and recommendations concerning the use and application of our products are based on tests we believe are reliable. However, the purchaser must test the suitability of our products for their intended use under their own operating conditions. Excelsior Steel Processing assumes no liability for claims beyond the replacement value of any defective products, and is in no way liable for consequential or incidental damages. These products are not suitable for prolonged outdoor exposure.